Publicité
Air Insert Adjustment
Warnings:
- Check inflation frequently, at least once a day!
- The air insert must be used with the air cells facing the individual.
- The individual's comfort level may be reduced if the air insert is the wrong
size, if it is not positioned correctly or is under-inflated or over-inflated.
- If the air insert does not appear to be holding air, see "Troubleshooting."
If the air insert is still not holding air, replace the air insert with the foam
insert and contact Customer Support or the distributor.
- Changes in altitude may require adjustment to the air insert.
- Keep the air insert away from sharp objects.
Caution: If the air insert has been in temperatures less than 32°F / 0°C and exhibits unusual stiffness, allow the air insert to warm to room temperature.
Then open the inflation valve, roll up the air insert, and then unroll it until the polyurethane is soft and pliable again. Repeat adjustment instructions before using.
To Adjust the Air Insert
Before adjusting the air insert, complete installation of the cover and AGILITY CARBON.
1. Slide the rubber nozzle of the hand pump over the inflation valve. Pinch
the nozzle and open the inflation valve. Inflate the air insert until it feels
firm.
3. The individual should
be seated in the
wheelchair in their
normal position. Open
the valve. Remove
air until the individual
is comfortable. Close
the valve. Make sure
the inflation valve is
closed.
Flip the Back Shell
1. Remove the product if it is already installed on
the wheelchair. See "Product Removal".
2. Rotate the back shell.
3. Follow all instructions to adjust and install the
product.
ROHO AGILITY CARBON Contour Back Support Operation Manual
- use the air insert as a seat cushion.
- use the inflation valve or hose as a handle to carry or pull the air insert.
- use the air insert as a water flotation device (e.g., a Life Preserver).
- use the following with an air insert: a pump, cover, foam pad or repair
Open
2. Pinch the rubber nozzle of the hand pump and close the inflation valve
until it comes to a stop. Remove the hand pump.
4. Detach the cover flap
closest to the zipper.
Place the valve hose
inside the cover.
Close the zipper and
reattach the cover flap.
14
DO NOT:
kit other than those compatible with the product. Doing so may void the
product's warranty.
Close
Publicité
