Publicité
Foam Pad and Air Insert Removal and Installation
Warning: Inspect the foam and air insert for damage and replace if necessary.
To Remove the Foam Pad and Air Insert
1. Detach the cover and foam from the back shell.
2. Unzip and remove the cover.
3. Detach the air insert from the fastener strip in the cutout area of the foam pad.
4. Pull the valve hose of the air insert back through the hole in the foam pad.
To Install the Foam Pad and Air Insert
Cutout Area
Foam Pad
Valve Hose
1. Slide the valve hose through the hole in the foam pad. The air cells
should face out.
3. Unzip the cover. Place the foam pad / air insert inside the cover. The air
insert should face the front of the cover. The wide and narrow ends of
the foam pad should be aligned with the wide and narrow ends of the
cover.
Foam Insert Installation
Warning: The air insert and the foam insert are not intended to be used together.
1. Remove the air insert from the foam pad. See "To Remove the Foam Pad and Air Insert".
2. Align the foam insert with the cutout area. Press to secure the fastener strips.
3. Unzip the cover and place the foam pad with the foam insert attached into the cover.
Note: The side of the foam pad with the foam insert should face the front of the cover. The wide and narrow
ends of the foam pad should be aligned with the wide and narrow ends of the cover.
4. Zip the cover closed and install the cover on the back shell.
ROHO AGILITY CARBON Contour Back Support Operation Manual
Air Insert
2. Tuck the edges of the air insert under all of the edges of the cutout area.
Press to secure the air insert to the fastener strip in the cutout area.
4.a. If adjustment of the air insert is not needed: Place the valve hose inside the
zipper area. Zip the cover closed. Install the cover on the back shell.
4.b. If adjustment of the air insert is needed: Partially unzip the cover to allow
access to the inflation valve. Install the cover on the back shell. See "To Adjust
the Air Insert".
13
4a
4b
Cutout Area
Foam Insert
Publicité
