Installing The Heater Railing (Optional) - Harvia Sentio Concept R mini combi CP-RMC-35 Instructions D'installation Et Mode D'emploi

Installation instructions, for professionals only
3. Guide the evaporator cable through the feed-
through 5.
4. Connect the wires of the evaporator cable to the
PE – N – U1 – Wm terminals on the connector
block and to the matching sauna control unit
terminals. Observe the installation instructions
for the sauna control unit when doing so.
5. Re-attach the cover plates 1 and 2 to the
sauna heater or proceed with the installation of
the heater railing (optional).

4.9. Installing the heater railing (optional)

1. Remove the ceramic bowl from the evaporator.
2. Remove the cover plates 1 and 2 as described in 4.9 on page 19.
ATTENTION!
Damage to the product
The product can be damaged by use of a cordless drill.
● Use a normal screwdriver to install the railing bracket.
3. Unscrew the screws B and remove
cover frame A.
B
p. 20/34
5
A
B