Publicité
EN
To change oil when:
•
Performance declines, for example insufficient vacuum;
•
Oil becomes cloudy.
•
Using the unit for 60 hours or 6000 times; In this case, the display will show a flashing "P".
•
When using the "Smart Vac" function, the display normally shows "AU". If showing "PAU" with a
flashing "P", it indicates that the pump has surpassed 6000 times of use and requires a pump oil
change. After oil changed, you can perform a "Factory Reset" to clear oil-filling reminder.
Factory Reset
Power the machine off then power it on. When the display shows "On", press and hold buttons "Stop"
and "Marinate" for about 3 seconds. The display will show "rS" and beep to restore factory settings.
Operation
•
Connect the power cord to the power port then plug in the appliance. The appliance will enter
Standby mode. Close the lid and the appliance will start to work for the selected mode.
•
When the lid is open, the display shows "ON".
•
When the lid is closed, the display shows "CLO" indicating the appliance is in protection mode. In this
mode, no matter which button is pressed, the appliance will not work. Open the lid to resume normal
operation.
•
For an extended period of use, we recommend a minimum interval of 20 seconds between operation
cycles.
Checking the pump operation counts
•
Before checking, ensure the lid is open and no items are placed inside the vacuum chamber. The
digital display will show "On".
•
Press and hold the "Customized Vac" and "STOP" buttons for 2 seconds. The display will flash and
show the pump operation count, alternating between "PX" and "XXX", where "X" represents the
numeric value. For example, if the pump has operated 1100 times, the display will alternate between
"P1" and "100". "P" stands for "PUMP". "P1" means the pump has operated 1000 times, and "100"
means an extra 100 times.
•
Press the "Stop" button to exit this mode.
Vacuum and seal
1. Choose a suitable-sized vacuum bag and place the item inside, leaving a minimum of 2 inches (5 cm)
between the item and the open end of the bag.
2. Press "Seal" button and
operation.)
3. Press "Smart Vac" button or "Customized Vac" button to select the vacuum mode. When in "Customized
Vac" mode, you can adjust the time with
4. Place the filled bag into the vacuum chamber with the open end over the seal bar. Ensure to clip the
lower/bottom side of the bag into the clip. The open end of the bag should be clean, free of liquid
and debris.
Note: Tuck only the bottom side of the bag so that the clip can support the upper side of the
bag.
5. Close the lid and the machine will start automatically. During operation, you can press "Seal" button
to switch to sealing immediately.
6. Upon sealing completion, the appliance will "beep" 3 times to remind the operation is done.
7. Open the lid and take out the bag. Check the vacuum and seal.
Note: A good seal will look clear upon inspection. If the seal is spotty, incomplete, wrinkled, white or
milky, remove sealed portion and run vacuum and seal process again.
6
HT497_ML_A5_v1_20240807.indb 6
/
to adjust the seal time. (The time will be saved for the next
/
buttons.
2024/8/7 19:14:12
Publicité
