Publicité
a long time, allow it to cool down
before let your child use it.
• WARNING: Prolonged exposure
to sublight can cause fading to the
fabric and materials colours.
• WARNING: Do not use this prod-
uct with temperature below 5°C or
on slippery and/or icy surfaces.
• WARNING: Do not use this prod-
uct as a sledge or raft in the water.
• WARNING: Always check that the
stoppers are fitted correctly and
show no sign of damage or tear.
• WARNING: When not in use, store
the baby walker in a suitable place,
away from contact with all weather
conditions and out of the reach of
children.
• WARNING: Do not allow oth-
er children to climb onto or play
without the supervision of an adult
near the baby walker.
COMPONENTS
A) Structure of the baby walker
B) Upholstered padded seat with semi-rigid backrest
C) 4 swivel wheels
D) 8 stoppers
E) Toy panel
(NOTE: The toy in the package may differ from the one
shown)
F) Fastening key for toy panel
FIRST ASSEMBLY
1. Turn over the structure of the baby walker (A). Attach the
front and rear wheels (C) in their slots (Fig. 1). Make sure
the pin has come to its limit: you will hear a click.
2. Fasten the stoppers (D) in the relevant slots (Fig. 2). Make
sure that the pins of all the stoppers have come to their
limit.
3. Bring the baby walker to position for use by turning the
wheels to the floor (horizontal plane); slowly lift the tray
as shown in (Fig. 3), by pulling it upwards until it clicks
into place in the desired position.
WARNING: Before putting the child in the baby walker,
make sure the button under the tray has reached its en-
gagement position (Fig. 4): an audible click indicates that
the button is locked.
4. Fit the padded seat plastic inserts (B) in the slots formed
along the top edge of the baby walker (Fig. 5A) and make
sure they are properly locked in the shown position (Fig.
5B). Then fasten the front pins (Fig. 5C).
BABY WALKER ADJUSTMENTS
WARNING: When opening, closing or regulating the baby
walker, make sure that your child is at a safe distance.
5. To adjust the seat height, after taking the child from the
baby walker, push the table upwards until it clicks into its
locked position (Fig. 6). To lower the height, hold the pin
under the table and turn it (Fig. 7), lower the table to the
desired position by sliding the pin. Upon release of the
pin, the tray automatically locks.
6. To close the baby walker, turn the pin under the tray (Fig.
8A) and lower the seat until it is completely closed (Fig. 8B).
WARNING: Do not close the baby walker with the child inside.
TOY PANEL
The toy panel has different activities to promote the child's
sensory, tactile and auditory development.
7. To fasten the toy to the frame, place it on the tray (Fig. 9).
To fasten it, push both keys upward (Fig. 10A) and turn
them as far as possible (Fig. 10B). To remove the toy, re-
peat the previous steps in reverse order (Fig. 11-12).
WARNING: This product must only be used under adult
supervision.
WARNING: Remove and keep out of reach of children any
hazards that might be a suffocation risk for the child such
as plastic bags and other components not belonging to the
toy (e.g. straps, fastenings etc.).
WARNING: Before using for the first time, check that the
product and all its components don't show signs of dam-
age caused by transportation. Check the product regularly
for signs of wear and damage. Keep all damaged parts out
of children's reach.
WARNING: Your child may be hurt if you do not follow the
instructions.
CLEANING AND MAINTENANCE
• This product requires periodical maintenance. The clean-
ing and maintenance of the product must only be carried
out by an adult.
• Clean the fabric and plastic parts including the stopper
with a damp cloth.
• Do not use solvents or abrasive products for cleaning.
• Dry the metal parts to prevent the formation of rust.
CARE & MAINTENANCE
WARNING: Protect the toy from heat, dust, sand and water.
WARNING: The baby walker is not designed to be used
when feeding a child; it is therefore recommended not to
use it during meal time.
WASHING TIPS
COMPOSITION: 100% polyester outer layer, 100% polyure-
thane inner layer
Hand wash in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
9
Publicité
