Settings And Adjustments; Track 360 - Husqvarna WS 460 Manuel D'utilisation

Track 360

Adjusting the rollers
In order for the saw to run stable and cut a straight line, the
rollers must be in contact with the track and not have too much
play. When there is too much play between the saw carriage
and track the rollers must be adjusted.
Adjusting the lower rollers
The lower rollers should be adjusted if vertical play is
observed between the saw carriage and the track.
To adjust, loosen the four 6 mm socket head setscrews
located at the bottom of the saw carriage. Loosening the
setscrews will allow you to turn the lower eccentric bushing.
Place a 0.05-0.08 mm (0,002"-0,003") shim between the roller
you are adjusting and the track. Rotate the eccentric bushing
using a 27 mm (1-1/6") socket until the shim is held frimly
beween the roller and the track but you can still pull it out.
Once this is achieved re-tigten the 6 mm socket head
setscrews.
NOTE!
Do not over tigthen the 6 mm socket head setscrews. This
could cause a slight deformity in the eccentric brushing which
could cause the plunge portion of the roller to stick.
NOTE!
The upper rollers located directly underneath the saw
carriage are fixed and cannot be adjusted.
14 –
English

SETTINGS AND ADJUSTMENTS

Adjusting the side rollers
The side rollers should be adjusted if side play is observed
between the saw carriage and the track.
To adjust, loosen the 4 mm socket head setscrew located on
the side of two of the saw carriage legs. Place a 0.05-0.08 mm
(0,002"-0,003") shim between the roller you are adjusting and
the track. To adjust, loosen the 4 mm socket head setscrew
located on the side of two of the saw carriage legs. Re-tighten
the 4 mm socket head setscrew. Repeat on the other
adjustable side roller.
NOTE!
Make sure that the carriage can be removed and re-installed
on the track. If it is difficult to re-assemble on the track, it is
being held-up by the side roller and needs to be re-adjusted
for more clearance.