Non-Ducted Recirculation Option - Faber INCA HC Instructions D'installation

4
Required Activated Charcoal Filter Accessory - sku # - FILTER1 (purchased
separately)
See page 11 Section 7 for installation instructions of Activated Charcoal Filter Accessory.
5
Min. 24"
Install the Insert Hood through the cabinet cutout into the cabinet opening that has a minimum
height of 16 ". Allow for ducting.
The range hood is secured to the cabinet cutout by two spring loaded brackets, one on each
side of the range hood.
It is recommend that the Insert Hood is supported with a 3/4" wood base to insure proper align-
ment of the two side clips
After the Insert Hood is installed into the cabinet opening lock it into position by tightening the
indicated screws in each of the two side clips from underneath the Insert Hood.
10

Non-Ducted Recirculation Option

For Non-Ducted Recirculation venting route the ductwork
to a location above the hood where the discharge is vented
back into the room.
Use the included
Recirculation Vent Grill
to cover the opening.
Secure the grill with the
2 screws provided in the
Install Kit.
2x
2x