Publicité
OBJ_BUCH-1600-005.book Page 35 Friday, December 16, 2016 9:23 AM
Settings
Bevel angle
Outer corner
Horizontal mitre angle
Positioning of work-
piece
The finished work-
piece is located ...
Ceiling Strips/Mouldings (According to US Standard)
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the standard mitre angles
52°
of 31.6° (horizontal) and 33.9° (vertical) must be set.
The following table contains instructions for sawing ceiling strips/mouldings.
38°
Settings
Bevel angle
Ceiling strip/moulding
Inner corner
Horizontal mitre angle
Positioning of work-
piece
The finished work-
piece is located ...
Outer corner
Horizontal mitre angle
Positioning of work-
piece
The finished work-
piece is located ...
Checking and Adjusting the Basic Adjustment
To ensure precise cuts, the basic adjustment of the machine
must be checked and adjusted as necessary after intensive use.
A certain level of experience and appropriate specialty tools
are required for this.
A Bosch after-sales service station will handle this mainte-
nance task quickly and reliably.
Adjusting the Laser
Note: To test the laser function, the machine must be con-
nected to power.
While adjusting the laser (e.g. when moving the tool
arm), never actuate the On/Off switch. Accidental start-
ing of the power tool can lead to injuries.
– Bring the power tool into the working position.
Bosch Power Tools
Placed
against the
fence
0°
45° right
45° left
Bottom edge on
Bottom edge on
saw table
saw table
... to the left of the
... to the right of the
cut
cut
Placed
against the
fence
52°
0°
Left side
Right side
45° right
45° left
Bottom edge
Bottom edge
against the fence
against the fence
... to the right of the
... to the left of the
cut
cut
45° left
45° right
Bottom edge
Bottom edge
against the fence
against the fence
... to the right of the
... to the left of the
cut
cut
– Turn the saw table 30 to the 0° detent 29. The lever 10
must be felt to engage in the detent.
– Switch the laser beam on with switch 31.
Checking: (see figure R1)
– Draw a straight cutting line on the workpiece.
– Press lever 22 and slowly guide the tool arm downward by
handle 4.
– Align the workpiece in such a manner that the teeth of the
saw blade are in alignment with the cutting line.
– Hold the workpiece in this position and slowly guide the
tool arm upward again.
– Clamp the workpiece.
The laser beam must be in alignment with the cutting line on
the workpiece over the complete length, also when the tool
arm is lowered.
English | 35
Lying flat on
the saw table
45°
0°
0°
Bottom edge
Upper edge against
against the fence
the fence
... to the right of the
... to the right of the
cut
cut
Lying flat on
the saw table
33.9°
Left side
Right side
31.6° right
31.6° left
Upper edge against
Bottom edge
the fence
against the fence
... to the left of the
... to the left of the
cut
cut
31.6° left
31.6° right
Bottom edge
Upper edge against
against the fence
the fence
... to the right of the
... to the right of the
cut
cut
1 609 92A 348 | (16.12.16)
Publicité
