Publicité
Brush installation
Automatic brush coupling, "Without Traction"
raise the machine head by pushing the head lift pedal down and then to
the left; using the function selector, select the Brush control and rest the
the head by pushing the head lift pedal down and then to the right, and
operate the drive lever repeatedly until the brush automatically engages
the lever again and repeating the centring procedure. Use of abrasive/
dryer.
1
3
21A
Automatic brush coupling, "With Electric Traction" version
(Fig.21B):
raise the head of the machine by depressing the head lift pedal and mov-
align it with the head. Lower the head by depressing the head lift pedal
and moving it to the right; turn the selector to the "OFF" position, press
the "SET" button once, then press the "+" button, and the machine will
1
3
PUSH
SET
21B
Automatic brush release
raise the machine head by pushing the head lift pedal down and to the
version, (Fig.21A):
left, turn the selector to the "OFF" position, press the "SET" button once
then press the "-" button, the machine will complete the release sequen-
ce.
2
22
Lifting and transporting the machine
All phases of lifting and moving must be performed in an adequately
illuminated environment with the adoption of the safety measures
Proceed as follows to load the machine onto a means of transport:
-
Quick head change
The scrubber head can be changed as described below.
Removing the head:
2
SET
Installing the head:
4
SET
PUSH
EN
(Fig.22):
1
3
PUSH
SET
! WARNING
most appropriate to the situation.
The operator must always use personal protection devices.
Empty the tanks.
Remove the batteries.
Push the machine onto the pallet using a sloping ramp, securing
the front wheels and the chassis using the brackets supplied.
The machine must not be raised.
Lift the pallet (with the machine) using a fork lift truck and load it
onto the means of transport.
Anchor the machine to the means of transport with cables con-
nected to the pallet and to the machine itself.
Lower the head.
Electrically disconnect the head from the machine's wiring, dis-
and disconnecting the motor connector/connectors.
Remove the head.
Perform the procedure described previously but in the reverse
order.
2
SET
4
SET
PUSH
13
Publicité
