Publicité
Frequency of cleaning/replacing the lter :
Filter
Pre filter
2in1 Active Carbon & Particle filter
Before carrying out any maintenance operation, be sure to unplug the power plug. You can use a slightly wet
cloth to clean the purifier body.
Important: Do not clean it with anything of grinding nature to avoid damaging to the surface of the purifier.
• When the 2-in-1 lter reaches 95% of saturation, the lter indicator will light up and the buzzer will ring
for one minute to remind the user to replace the 2-in-1 lter.
• * The ashing light indicates that the usage of the lter mesh is about to end.
• The lter indicator will ash when the 2-in-1 lter is full of dust then you must replace it with a new 2-in-1
lter
Performing a force reset:
The filter indicator lights up on the control panel and the buzzer rings for one minute each time the purifier
is switched on, to remind the user to replace the 2-in-1 filter. After you replace it, press the « night button »
for 3 seconds to reset the filter.
If the 2-in-1 filter is replaced before its end of life, the timing of the 2-in-1 filter should be reset by force:
1. After replacing the 2-in-1 filter, press and hold the sleep mode button for 3 seconds;
2. The corresponding filter indicator light flashes;
3. Press and hold the sleep mode button for 3 seconds again, the filter indicator light goes out and the
buzzer beeps twice, then the purifier will recalculate the usage of the 2-in-1 filter.
4. The reset mode will be canceled, if there is no operation for 3 seconds
Caution :
*The working efficiency of the pre-filter will be reduced if cannot be cleaned regularly
*Do not use a wet pre-filter
*Do not wash or reuse too many times the 2-in-1 filter
*Replace the filter mesh in turns, please refer to"Before use" ------"Frequency of cleaning/replacing the filter"
Please note: certain filters may emit a temporary slight odour, due to the transport and storage conditions.
« TIPS FOR CHANGING FILTERS »
• Avoid handling used lters if you su er from allergies or asthma.
• Wear gloves when changing the lters, or wash your hands well afterwards.
• Put used lters directly into a closed, air-tight bag before throwing them away to avoid
spreading pollutants.
IMPORTANT:
Never use a detergent or metal object to clean the sensors.
The efficiency of the sensors may be reduced if not cleaned regularly.
Cleaning frequency varies depending on the operating environment of the appliance. If it is used in a dusty
environment, clean the sensors more frequently.
STORAGE
When you are not using the appliance, store it in a cool, dry place with ambient conditions no higher than 35°C
70%RH.
6
Clean/replace
Clean
Every 2 months
Replace
Every 12 months
Frequency
Filter codes
XD6220F0
Publicité
