CARE & CLEANING
Ensure the juicer is turned off by switching the
ON / OFF button on the control panel to OFF.
Then switch the appliance off at the power outlet
and unplug the power cord.
Ensure the juicer is correctly disassembled.
Refer to Disassembling your new appliance.
FOR EASIER CLEANING:
• Clean as you go and avoid dried on juice
or pulp residue.
• Immediately after each use, rinse removable
parts in hot water to remove wet pulp. Allow
parts to air dry.
NOTE
To minimise cleaning, line the pulp container
with a plastic freezer bag to collect the pulp.
Pulp can then be used for other dishes, or
as compost for the garden or discarded.
CLEANING THE MOTOR BASE
• Wipe the motor base with a soft, damp cloth
then dry thoroughly.
• Wipe any excess food particles from the
power cord.
NOTE
Do not use abrasive scouring pads or
cleaners when cleaning the parts or motor
base as they may scratch the surface.
CLEANING THE FILTER BOWL
SURROUND, JUICER COVER,
FOOD PUSHER, PULP CONTAINER
Wash all parts in warm soapy water with
a soft cloth. Rinse and dry thoroughly.
NOTE
The filter bowl surround, juicing jug and
lid, food pusher and pulp container, are
dishwasher safe (top shelf only). The juice
cover is not dishwasher safe.
CLEANING THE FILTER BASKET
• For consistent juicing results always
ensure that the stainless steel filter basket
is thoroughly cleaned using the supplied
cleaning brush. It is important to do this
immediately after use.
• Soak the stainless steel filter basket in hot
soapy water for approximately 10 minutes
immediately after juicing is completed. If pulp
is left to dry on the filter it may clog the fine
pores of the filter mesh thereby lessening the
effectiveness of the juicer.
• Using the cleaning brush, hold the filter
basket under running water and brush from
the inside of the basket to the outer rim.
Avoid touching the small sharp blades in
the centre of the filter basket. Repeat this
process on the outside of the basket. After
cleaning the filter basket, hold it up towards
a light to ensure the fine mesh holes are not
blocked. If the holes are blocked, soak the
filter basket in hot water with 10% lemon
juice to loosen the blocked holes. Repeat the
cleaning process using the cleaning brush.
Alternatively, wash the filter basket in the
dishwasher.
EN
9