Publicité
TROUBLESHOOTING
POSSIBLE PROBLEM
Machine will not work
when switched ON
Motor appears to stall
when juicing
Excess pulp building
up in the stainless steel
filter basket
EASY SOLUTION
• The safety locking arm may not be correctly engaged in the vertical
operating position with the locking arm located into the two grooves
on either side of the juicer cover.
• Wet pulp can build up under the juicer cover if the juicing action is
too vigorous. Try slower juicing action by pushing the food pusher
down more slowly. Follow Disassembling and Cleaning instructions
and clean the filter bowl surround, the stainless steel filter basket
and the juicer cover.
• The juicer will automatically stop operating if the motor is stalled for
more than 10 seconds. Either too much food is being processed at
one time or the pieces are not small enough. Try trimming the food
or cutting into smaller pieces of even size and processing a smaller
amount per batch. To continue juicing, reset the juicer by pressing
the ON / OFF switch on the control panel back to OFF then turn the
appliance back on by pressing ON / OFF switch to ON.
• Hard fruit and vegetables will put excess strain onto the motor if a
low speed is selected. Please refer to the juicing guide to determine
the correct speed for the fruit and vegetables selected for juicing.
Please ensure the motor is running prior to loading the chute.
• Stop the juicing process and follow Disassembling instructions.
Remove the juicer cover, scrape off pulp, reassemble and begin
juicing again. Try alternating (soft and hard) vegetables and fruit
varieties.
EN
11
Publicité
