Communication; Interface Commands - OHAUS Pioneer PX Série Manuel D'instruction

EN-44
9.4

Communication

9.4.1 Interface Commands

Commands listed in the following table will be acknowledged by the balance.
Command
Function
Characters
IP Immediate Print of displayed weight (stable or unstable).
P Print displayed weight (stable or unstable).
CP Continuous Print.
SP Print on Stability.
H Enter Print Header Lines
Z Same as pressing Zero Key
T Same as pressing Tare Key.
xT*** Establish a preset Tare value in displayed unit. X = preset tare value. Sending 0T clears tare
(if allowed).
PT Prints Tare weight stored in memory.
ON Brings out of Standby
OFF Goes to Standby.
C Begin Span Calibration
IC Begin Internal Calibration, same as trigger from calibration menu.
AC Abort Calibration. Attention: when LFT ON, the operation is not allowed.
PSN Print Serial Number.
PV Print terminal software version, base software version and LFT ON (if LFT is set ON).
x# Set Counting APW (x) in grams. (must have APW stored)
P# Print Counting application APW.
x% Set Percent application reference weight (x) in grams. (must have reference weight stored)
P% Print Percent application reference weight.
xRL 0 = disable response; 1 = enable response. This command only controls the "OK!" response.
xT Pre-tare the container weight (x) in grams.
PX Series Balance