Adjustment Options (Dealer) - Handicare IBIS XC Manuel D'utilisation

Operating instructions
•
The wheelchair should be
secured only at the tie-down
points on the frame, not onto
any accessories (armrest, anti-
tip brackets, etc).
•
Apply the wheelchair brake.
•
Handicare recommends that the
wheelchair be supplied with a
headrest and that this should be
used during transportation.
•
During transportation it is
essential that you are secured
by a three point lap belt, which is
anchored to the vehicle wall and
floor rails. A lap belt in your
wheelchair must not be
considered as an alternative to
the occupant restraint system.
3.9 Adjustment options
(dealer)
The seat tilt range can vary
depending on the way the
wheelchair is adjusted.
Seat height
Before adjusting the seat height,
remove as many heavy seat parts as
possible (seat, backrest, etc.) to limit
the weight to be lifted.
34
1. Loosen the 4 bolts (A) using a 13
mm spanner, and remove them.
2. Lift the seat post off the bracket (B)
and place it back in the desired
position on the bracket.
3. Tighten the bolts (A) securely.
Seat angle
1. Tilt the seat with the seat tilt
adjustment, so that the adjusting
plate becomes free.
2. Loosen the bolt (A) with a 4 mm
Allen key, and remove it.
3. Loosen the bolt (B) a few turns.
4. Turn the plate © in the desired
position (angle).
5. Tighten both bolts (A and B)
securely.