Simple Reset - Häfele FT 200 Instructions D'utilisation

12.1 Simple reset

A simple reset is required in the following cases:
• Loss of programming and erasing key (master keys).
After a simple reset, the allocated master keys are cleared and reallocation is required (LED
continuously flashing in green).
Continued use of the terminal is not possible until a restart with new master keys (
up, page 51). The locking authorisations for the user keys are retained after a simple reset.
Prerequisites:
1. Press the reset button.

A brief acoustic signal is heard.
A tool to actuate the reset button, such as a thin pen/pencil or
opened out paper clip
< 1s
2. Press and hold the reset button until a long
acoustic signal is heard.

The lock on parametrisation with the MDU
110 data transfer unit is disabled.

The LED flashes continuously in green.
3. Re-teaching master keys

( 5. Start-up, page 51)

5. Start-
> 1s
71