Factory Settings - Häfele FT 200 Instructions D'utilisation

Latchbolt lock operation / self-locking action (= factory setting)
In latchbolt lock operation, the locks are unlocked during the open time. The locks then lock
automatically once the open time has elapsed (self-locking action).
Deadbolt lock operation (permanent open)
In deadbolt lock operation, all locks are permanently unlocked during the open time
(permanent open). The locks are locked by presenting one of the user keys that is authorised
for deadbolt lock operation again.
Deadbolt lock operation can be enabled in two ways:
• With appropriately programmed user keys
function, page 56
• By setting the FT 200 / FT 200 CAP furniture terminal to permanent deadbolt lock operation

8.3 Programming permanent deadbolt lock operation, page 60
Permanent deadbolt lock operation is then enabled for all locks and all authorised user keys.
It is deactivated by re-entering an open time (
means of a complete reset (
Operation with 2 antennas
Operation with 2 antennas can take place in two ways:
operation mode
Parallel operation (standard)
Separate operation (macro)

3.4 Factory settings

Parameter
Open time (duration of unlocking period in latchbolt lock operation)
• The open time can be set to up to 30 seconds at one second intervals
in stand-alone operation

8.5 Adjusting the open time, page 64.
• The open time can be extended to beyond 30 secs using the MDU
110 with special functions or macros.
Type of locking
48

6.3 Programming a user key with deadbolt lock

8.5 Adjusting the open time, page 64) or by

12.2 Complete reset, page 72).
Description
• Same functionality at both antennas
• The EFL 3 / EFL 3C outputs on the FT 200 / FT 200 CAP (or on
the MLA 8 / MLA 6 P multi-lock adapters) can be allocated
separately to both antennas. In this way, they can be operated
independently of each other via antenna 1 or antenna 2. A macro
is required for this application.
Value
3 sec.
Latchbolt lock operation