User Key Allocation By Unlocking The Locks - Häfele FT 200 Instructions D'utilisation

8.4.2 User key allocation by unlocking the locks

Locks which are not to be allocated to the respective user key must be safeguarded
against unintentional unlocking (e.g. with a small wedge, adhesive tape or the like).
Several user keys can be allocated to one lock.
Example:
• User key 1: Locks 1, 3, 5
• User key 2: Locks 3, 5, 7, 10
• User key 3: Locks 1, 2, 5, 10, 12
Tag-it ™ISO
Prerequisites:
1. Hold the programming key card in front of the
antenna until the acoustic signal sounds 3x.

The LED illuminates in green.

All locks are unlocked.
3. Hold the required user key in front of the
antenna.

The LED continues to flash in green.

All locks are briefly locked so unlocked locks
can be recognised.

A brief acoustic signal is heard

The user key is now allocated to all unlocked
locks.
If no lock is unlocked when the user key is presented, an acoustic signal will sound:
• Two short acoustic signals sound and the LED switches briefly to red.
Programming key card
3x
#1
#2
#...
The programming mode for normal user keys is
now active for 10 seconds and the LED flashes in
green.
2. Manually unlock all locks to which the user key
is to be allocated.
4. Remove user key.

The LED continues to flash in green for
approx 10 seconds.

If no other user keys are allocated,
programming mode ends automatically and
the LED switches to red.

All locks are locked.
5. Lock all unlocked locks manually.
Userkey
10 s
#1
#2
#...
10 s
#1
#2
#...
63