Publicité
RECOMMENDED CUTTING EQUIPMENT FOR CANADA
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of powerhead, bar
and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available
at your dealer.
Length, inch
Pitch, inch
15
3/8
16
3/8
18
3/8
20
3/8
24
3/8
28
3/8
0,050"/1,3 mm
H46
0,058"/1,5 mm
H42
WARNING! This chain saw model is capable
!
of severe kickback that could result in
serious injuries to the user. Do not operate
this saw unless you have extraordinary
cutting needs and experience and
specialized training for dealing with
kickback. Saws with significantly reduced
kickback potential are available. Always use
the safest saw and cutting equipment
applicable to your cutting need.
Saw chain filing and file gauges
38 –
Canadian
All manuals and user guides at all-guides.com
TECHNICAL DATA
Bar
Gauge, inch
Max. nose radius
1,5
11T
1,5
11T
1,5
11T
1,5
11T
1,5
11T
1,5
11T
H47
H48
Chain
Type
Drive link count
Husqvarna H42,
56
Husqvarna H48
60
68
72
84
93
Publicité
