Télécharger Imprimer la page

Eneo TPP-72A0030P0A Guide D'installation Rapide page 7

Publicité

Setting Dome Camera Address (ID)
Hole cover
NOTICE: Open the hole cover and change the setting of DIP switch. The cover
i
should be closed after setting DIP switch.
To prevent damage, each dome camera must have a unique address (ID). The factory
default setting is 1.
Refer to Dome Communication section for detailed information.
Setting Video Type & Coaxitron Protocol
You can set video signal with D1 and termination with D2 in SW1.
SW1-D1
Video Signal
OFF
NTSC
ON
PAL
EN
7

Publicité

loading