Publicité
Problem
An acoustic signal sounds and the
hob deactivates.
An acoustic signal sounds when the
hob is deactivated.
The hob deactivates.
Residual heat indicator does not
come on.
Automatic Heat Up does not oper-
ate.
The heat setting changes between
two levels.
The sensor fields become hot.
comes on.
comes on.
and a number come on.
Possible cause
You do not set the heat setting for
10 seconds.
You touched 2 or more sensor fields
at the same time.
There is water or fat stains on the
control panel.
You put something on one or more
sensor fields.
You put something on the sensor
field
.
The zone is not hot because it oper-
ated only for a short time or the sen-
sor is damaged.
The zone is hot.
The highest heat setting is set.
Power management operates.
The cookware is too large or you
put it too near to the controls.
Child Safety Device or Lock oper-
ates.
There is no cookware on the zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
There is an error in the hob.
Remedy
Activate the hob again and set the
heat setting in less than 10 sec-
onds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
Let the zone become sufficiently
cool.
The highest heat setting has the
same power as the function.
Refer to "Daily use".
Put large cookware on the rear
zones if possible.
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Refer to
"Hints and tips".
Use cookware with correct dimen-
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
comes on again, disconnect the hob
from the electrical supply. After 30
seconds, connect the hob again. If
the problem continues, speak to an
Authorised Service Centre.
25
Publicité
