Connecting A Display Unit; Operation; Initial Commissioning - KERN and SOHN KFP V20NM Série Mode D'emploi

6.4 Connecting a display unit

Attention
Put the connecting cable to the display unit in a manner that it is protected against
damage.
Description of the connection cable:
terminal
EXC+ [IN+]
SIG + [OUT+]
SIG -[OUT-]
EXC -[IN- ]

7 Operation

Information about
• Network connection (power is supplied via the connecting cable of the
display unit)

• Initial Commissioning

• Connection of peripheral devices
• Adjustment, linearization and verification (only the complete balance is
verifiable, i.e. weighing bridge in conjunction with a suitable display unit)
and the correct operation you will in the operating instructions included in the scope
of delivery of the display unit.
10
Color
red
blue
green
yellow
So a continuous optimal performance is guaranteed:
• Avoid falling load, shock loads and impacts from the side!
• For weighing operation, all objects must be placed
centrically of the weighing bridge and may not hang over
the edges or the ramps.
• Check adjustment at regular intervals.
State
voltage +
signal +
signal -
voltage -
KFP V20NM-IA-e-1712