Publicité
If the STATUS LED on the transmitter does not turn green, repeat the binding procedure.
You must power off your transmitter and receiver(s) after binding.
Your Graupner|iFS system is now ready for use, when the STATUS-LED on the transmitter lits
green and on the receiver red!
You must set the hopping mode prior to binding!
The hopping information is transferred during the binding process. If you change the hopping
modes, you must rebind all receivers.
Multiple receiver support is not available in Hopping mode 1. Only Modes 2-5 support multiple
slave receivers!
WARNING!
HOPPING MODES 2-5
If two or more receivers are turned on at the same time, and the transmitter is turned on "any" of
the receivers may lock on to the transmitter.
The other receiver will not lock (unless set as a slave).
Turning on and off your transmitter will cause receivers to lock and unlock! For this reason,
please make sure that your last model is turned off before flying the next model!
4. RANGE TESTING
NOTE: The range with the antenna off and PROG button pressed when using the v3.0 and later
firmware will be noticeably less than previous versions. This is due to the fact that the power
level is now 25 times lower than previous versions when pressing the PROG button.
To perform a range test of the Graupner|iFS, follow the instructions below.
Have someone help during this procedure.
4.1 Range test
1. Install the receiver in the R/C device as it will be used.
2. Turn on the radio system so servo movement can be observed.
3. Using flat ground (pavement, low cut grass or dirt) place the R/C device so that the receiver
antenna is no less than 6" (15 cm) from the ground. This might require you elevating the R/C
device during the testing.
4. Hold your transmitter waist high, away from your body.
5. Press and hold the PROG button on the transmitter module.
6. Walk to a distance of at least 33 feet (10 m). If at any time you experience a pause in controls,
try to reproduce it again and release the button to see if the pause no longer occurs. If the
problem does not occur now, check to make sure that your receiver is at least 6" (15 cm) from
the ground while testing.
7. With the PROG button still pressed down, walk away from the R/C device while moving the
sticks until there is intermittent control. If it does not respond 100% fully, do not use the system
and contact Graupner GmbH & Co. KG for assistance!
8. Test complete.
Bedienungsanleitung IFS
All manuals and user guides at all-guides.com
Seite 14
Publicité
