Publicité
-Reinstall the broiler d rawer. Complete i nstallation s ec-
tionsDthrough E,Pages 9 -11. Checking forproper
c ooktop
burner and oven flame is very important.
YOU MUST ADJUST "LOW" SETTING FOR EACH COOKTOP
BURNER AS IN STEP 16, PAGE10.
The small inner cone should have a very distinct blue flame
1/4" to 1/2" long.The outer cone is not as distinct as the
inner cone. L.R gas flames have a slightly yellow tip. If the
flame is noisy or blowing, it is getting too much air. If the
flame is soft and lazy, it is not getting enough air.
Natural gas conversion
,,Check that main gas supply line has been shut off and
the power supply cord is disconnected.
pressure
regulator_
.....
_--
-Open broiler drawer to locate pressure regulator.
Pressure regulator: Remove plastic cover. Turn cap marked
"L.F' on front of pressure regulator counterclockwise with a
wrench to remove. Do Not disturb or remove the spring
beneath the cap.Turn the cap over and reinstall cap on
regulator so that the letter "N" is visible. Replace plastic
cover over cap.
_
reinstall
orifice
L_
one of the
[] Surface Burners:
spud
_
screws
Remove burner caps. Use
\
y_
.............
• •
orifice
_
_-_J
=_,=,_ =,_,..uu_
a
Phdllps or Quadrex
spud " \_/_
- _ _,\\_
/
screwdriver to remove
holder'_--
_X_'X_,__/
the two screws holding the
_t _(\/?_-'_'_) )JL_'.P,L_:W
burner head down. Lift the
\\\_//_
burner head off the cooktop
_
J_
to uncover the orifice spud
range cooktop
holder.The orifice spud is recessed in the holder.
Note: Reinstall one of the screws through the range cooktop
to hold orifice spud holder in place while removing and
replacing orifice spuds.
Locate the Natural gas orifice spuds in
literature package. Orifice spuds are
stamped with a number and marked with
two color dots.
5/16"
nut driver
Natural
gas
orifice
spud
orifice spud.
Replace orifice
_-L_
spud with the
J_q:::2::::_
number listed
/(
_
"_
in chart.
/_'-_
orifice
burner
/
number
assembly
pressure
_
regulator
plastic
cover
plastic
cover
cap
washer
--
Nat. gas
L.R gas
DO NOT REMOVE THE PRESSUREREGULATOR.
Natural Gas
Surface
Propane
Orifice
Color
burner
Rate(BTU/hr)
Number
Marking
Left rear
8,000
N 139
Blue/Black
Left front
12,000
N 176
Bhe/Red
Right front
9,500
N 151
Bhe/Brass
Right rear
5,000
Nl12
Bhe/Whke
A brass orifice spud is located in the center of each burner
throat about 2" below the cooktop. Apply masking tape to
the end of a 5/16" nut driver to fit snugly over the orifice
spud. Press driver down onto the spud of the left front
burner and remove by turning spud counter-clockwise and
lifting it out. Replace the L.R gas spud with the appropriate
Natural gas spud shown in the table.
Continue to replace the remaining orifice spuds, one at a
time. Place the L.R gas spuds in plastic parts bag for future
use and keep with literature package. Replace burner caps
using both screws, and burner grates.
Page 13
Publicité
