Publicité
17 Inspect Exterior Graphic
If bubbles are present after premask carrier removal, wrap a towel around the
squeegee and carefully attempt to push the bubble to the side of the Exterior
Graphic. If the bubble cannot be moved, use a sewing needle to pierce the
bubble and press the remaining solution from beneath the Exterior Graphic.
Premask / Handling Tab
Exterior Graphic
Liner
19 Separate Liner
Remove liner from Exterior Graphic as shown. To prevent
contamination, limit touching adhesive side of the Exterior Graphic
by using handling tabs.
21
Exterior Graphic Placement
While using the handling tabs align the Exterior Graphic into
position.This allows the part to float on the surface until proper
fit is achieved.
DESCRIPTION
Exterior Graphics - Side
Exterior Graphic
Liner
Premask
ISSUE
DATE
00
12/9/21
18 Dry Fit
Align the Exterior Graphic into position using the handling tabs,
door notches and panel edges as references.
20
Spray Vehicle / Adhesive of Exterior Graphic
Spray the adhesive side of the Exterior Graphic with the soap
and water solution. Then spray the vehicle surface where the
Exterior Graphic will be installed.
22
Spray Exterior Graphic Premask
Spray the top surface of the premask with the soap and water
solution. This makes it possible for the squeegee to slide easily
across the surface.
SUBARU OF AMERICA
PAGE
5 / 7
Publicité
