Premask / Handling Tab
Exterior Graphic
Liner
11 Separate Liner
Remove liner from Exterior Graphic as shown. To prevent
contamination, limit touching adhesive side of the Exterior Graphic
by using handling tabs.
13
Exterior Graphic Placement
While using the handling tabs align the Exterior Graphic into
position.This allows the part to float on the surface until proper
fit is achieved.
15
Squeegee Exterior Graphic
Use caution not to scratch the paint surface with the squeegee.
Using smooth even overlapping strokes squeegee the Exterior
Graphic into position.
DESCRIPTION
Exterior Graphics - Side
Exterior Graphic
Liner
Premask
ISSUE
DATE
12/9/21
00
12
Spray Vehicle / Adhesive of Exterior Graphic
Spray the adhesive side of the Exterior Graphic with the soap
and water solution. Then spray the vehicle surface where the
Exterior Graphic will be installed.
14
Spray Exterior Graphic Premask
Spray the top surface of the premask with the soap and water
solution. This makes it possible for the squeegee to slide easily
across the surface.
Premask
Exterior Graphic
16 Remove Premask
Carefully remove the premask from the Exterior Graphic by slowly
lifting and pulling backward at an 180º angle as shown.
SUBARU OF AMERICA
PAGE
4 / 7