Publicité
5 Exterior Graphic Placement
While using the handling tabs align the Exterior Graphic into
position.This allows the part to float on the surface until proper
fit is achieved.
7
Squeegee Exterior Graphic
Use caution not to scratch the paint surface with the squeegee.
Using smooth even overlapping strokes squeegee the Exterior
Graphic into position.
9
Inspect Exterior Graphic
If bubbles are present after premask carrier removal, wrap a towel around the
squeegee and carefully attempt to push the bubble to the side of the Exterior
Graphic. If the bubble cannot be moved, use a sewing needle to pierce the
bubble and press the remaining solution from beneath the Exterior Graphic.
DESCRIPTION
Exterior Graphics - Side
6
8 Remove Premask
10 Dry Fit
ISSUE
DATE
00
12/9/21
Spray Exterior Graphic Premask
Spray the top surface of the premask with the soap and water
solution. This makes it possible for the squeegee to slide easily
across the surface.
Carefully remove the premask from the Exterior Graphic by slowly
lifting and pulling backward at an 180º angle as shown.
Align the Exterior Graphic into position using the handling tabs,
door notches and panel edges as references.
SUBARU OF AMERICA
Premask
Exterior Graphic
PAGE
3 / 7
Publicité
