Publicité
Lock washer (H)
Corner cap
$ ga
Hex nut ()
Corner cap
Hex bolt (D)
Fig. 10
Hex nut {1)
(Use 1/4" x1 1/2" (6X40 mm) bolts (G)
Fig. 11
Cotter key (A)
Fiat washer (B)
Valve stem
(outside)
Hub cap (C)
Fig. 12
17. Assemble large diameter flat washer (B), wheel, another flat
washer (B), cotter key (A) and hub cap (C) to each axle end.
N.B. Position valve stem to outside when installing wheels on axle.
See figure 12.
18. Assemble latch lock sub-assembly to draw bartongue using
1/4"
x 5/8 (6x 16 mm) long hex bolt (E), lock washers (H) and
hex nuts (l). See figure 13.
Latch lock sub-assembly
Dd Hex bolt (E)
7
Drawbar tongue
|
(Sa
Lock washer (H)
Hex nut (1)
Fig. 13
Drawbar tongue
|
| |
~ Lock washers (N)
Hex nuts (O)
Fig. 14
19. Assemble hitch bracket to drawbar tongue, using 3/8"x1"
(10x25 mm) long hex bolts (M),lock washers (N) and hex nuts
(O). See figure 14.
20. Lower the cart assembly to rest on wheels. This completes
the cart assembly. Be sure to read safety rules and operating
instructions before using your new utility cart.
Publicité
