Publicité
All manuals and user guides at all-guides.com
4.4.9 POWER TAKE-OFF (7:Q)
The power take-off must never be
engaged when the front-mounted
implement is in transport position. This
will destroy the belt transmission.
A lever for engaging and disengaging the power
take-off for operating the cutting deck. Two
positions:
1.Forward position – power take-off
disengaged.
2. Backward position – power take-off
engaged.
4.4.10CLUTCH RELEASE LEVER (fig. 8)
(2125H)
A lever for disengaging the variable transmission.
Enables the machine to be moved by hand without
the help of the engine.
The disengagement lever must never be
between the outer and inner positions.
This overheats and damages the
transmission.
Two positions:
1. Lever pressed in –
transmission engaged for normal
operation.
2. Lever pulled out –
transmission disengaged. The
machine can be moved by hand.
The machine may not be towed over long distances
or at high speeds. The transmission could be
damaged.
5 AREAS OF USE
The machine may only be used for the following
tasks using the genuine GGP accessories stated.
Mowing:
With cutting deck 85 Combi.
The maximum vertical load on the towing hitch
must not exceed 100 N.
The maximum over-run load on the towing hitch
from towed accessories must not exceed 500 N.
NOTE! Before using a trailer – contact your
insurance company.
NOTE! This machine is not intended to be driven
on public roads.
ENGLISH
6 STARTING AND OPERATION
The machine may not be operated
unless the engine casing is folded down.
Risk of burns and crushing injuries.
6.1 FILLING THE FUEL TANK
See fig. 9. Open the engine casing as above.
Unscrew the filler cap and fill with clean, lead-free
petrol. You must never use 2-stroke petrol mixed
with oil.
NOTE! Bear in mind that ordinary lead-free petrol
is a perishable; do not purchase more petrol than
can be used within thirty days.
Environmental petrol can be used, i.e. alkylate
petrol. This type of petrol has a composition that is
less harmful for people and nature.
Petrol is highly inflammable. Always
store fuel in containers that are made
especially for this purpose.
Only fill or top up with petrol outdoors,
and never smoke when filling or
topping up. Fill up with fuel before
starting the engine. Never remove the
filler cap or fill with petrol while the
engine is running or still warm.
Never completely fill the petrol tank. Leave an
empty space (= at least 2-3 cm at the top of the
tank) to allow the petrol to expand when it warms
up without overflowing.
6.2 CHECKING THE ENGINE OIL
LEVEL
On delivery, the crankcase is filled with SAE 10W-
30 oil.
Check the oil level every time before using to
ensure it is correct. The machine should be
standing on level ground.
Wipe clean around the oil dipstick.
Unscrew and pull it up. Wipe off the
dipstick. Slide it down completely and
tighten it.
Then unscrew it and pull it up again. Read off the
oil level. Top up with oil to the "FULL" mark, if
the level comes below it (fig. 10).
The oil level must never exceed the "FULL" mark.
This results in the engine overheating. If the oil
level exceeds the "FULL" mark, the oil must be
drained until the correct level is achieved.
EN
11
Publicité
