Publicité
Assembly of accessories
3
Height adjustment of push handles
Insert push handles at least to the fi rst cross hole into the
frame tubing. Insert the fi xing screw from the inside
and tighten using the washer and star screw (pic. 4).
To change the height adjustment of the push handles,
loosen the fi xing screw by turning the star screw counter-
clockwise. Then lock the handle at the desired height, as
described above (pic. 5).
4
Cane Holder
Put the upper cane holder with the pins into the 2 holes
at the push handle pipes below the backrest and close
the clip. The lower cane holder part must be fi xed with
the pin in the fi xation whole. Make sure correct assembly.
(pic. 6-7). The cane holder can be mounted left or right.
6
Tires
Check the air pressure of the wheels at regular intervals.
To infl ate the wheels, open the valves by turning the caps
clockwise. After the wheels are infl ated, close the valves
again with the caps.
Drive Medical GmbH & Co. KG | As per: 25.01.2024 | Errors and alterations excepted
The pocket is hung by its
loops from the ends of the
frame tubing (pic. 3).
5
7
To infl ate the wheels, use a hand air pump with the ap-
propriate attachment.
Depending on the air pressure of your wheels, the set-
tings of the brakes may have to be adjusted.
Recommended air pressure: 2.0 - 2.4 bar
Adjusting the brakes
If braking is poor or too hard, the brake can be adjusted
either at the brake housing above (pic. 8) or using the
adjusting screw on the Bowden cable below (pic. 9) to
achieve the desired braking eff ect.
The brake is correctly adjusted when the brake lever as
well as the brake wires are free of play and the wheels
can be rotated without grinding noises when the brake
is released.
8
Braking | Parking
10
11
The braking eff ect can be impaired by wear and tear and
the air pressure on the tires. For this reason, regularly
check the braking eff ect.
9
To brake when walking
with the rollator, pull both
brake handles upwards
with your hands (pic. 10).
Always brake slowly while
applying equal pressure
with both hands.
To apply the brakes/park
the rollator, press both
brake
handles
down-
wards until they audibly
click into place (pic. 11)!
To release the brake, pull
both brake handles up-
wards once again until
they are released (brake
handles are in the middle
position).
Instructions for use TORRO Activo
EN
13
Publicité
