Publicité
ENGLISH
Accessories
Vacuum head
The vacuum head is suitable for both carpets and hard floors.
Accessory for corners
Use this accessory to clean corners, recesses, edges, and other hard-to-reach places.
2-in-1 accessory
Use this accessory to clean upholstered surfaces, keyboards, lamps, curtains, blinds, vents,
etc. To switch between the wide side and narrow side, press the button on the accessory and
slide the brush up or down. Fig. 8
Accessory for pets. Fig. 9
-
This accessory allows you to effortlessly brush and cut tangles (depending on the head
you use) from your pet's coat.
To attach the accessory for pets to the main body, align and fit both until the accessory
-
clicks into place. For ease of handling, we recommend the use of this accessory in
conjunction with the extensible tube.
-
To remove the accessory, press the accessory for pets release button with one hand while
holding the main body firmly with the other.
-
Press the head release button to remove the head so that the desired head can be fitted.
To attach the head, insert the lower tabs and then press the upper part until it clicks into
place.
Press the trigger to release the hair and instantly vacuum it.
-
Fig. 9 key:
1. Head release button
2. Trigger
3. Accessory for pets release button
5. CLEANING AND MAINTENANCE
Always turn off and unplug the vacuum cleaner before cleaning or maintenance.
-
-
Use a soft, slightly dampened cloth to clean the surface of the appliance.
-
Never immerse the appliance in water or other liquids. Do not allow liquids to enter the
appliance.
Do not use abrasive cleaners or scouring pads to clean the device.
-
-
Do not leave the vacuum cleaner in a place with direct sunlight.
-
Do not leave the vacuum cleaner in a wet place after cleaning it.
-
After the brush has been used for a long time, bristles might start to tangle with hair and
other dirt. Clean the brush to ensure cleaning efficiency.
40
CONGA ROCKSTAR 7500 ASTRAL FLEX ANIMAL
Cleaning the dust tank and the filters
1. Press the dust-tank release button and remove it. Fig. 10
2. Press the dust-tank release button to open the tank cover and empty it. Fig. 11
3. Use the cleaning brush to clean the filter. Fig. 12
4. Hold the dust tank, remove the filter, and lift the filter cover to remove the parts inside.
Fig. 13
5. Wipe all parts with a slightly damp cloth.
6. After cleaning the filter, press the on/off trigger for 3 seconds to restart.
Cleaning the motor filter. Fig. Fig. 14
1. Turn the filter cover counterclockwise to remove it.
2. Remove the filter and clean it.
It is recommended to clean the filter at least every six months.
Cleaning the brush and the vacuum head
1. Press the release tab on the hard floor brush and remove the brush as shown in figure 15.
2. Remove hair and debris around the brush with your fingers or the cleaning brush blade.
3. Wash the brush under running water.
4. Allow the brush to dry completely before reassembly.
5. Replace the brush.
Warning:
-
The motorised brush includes electrical connections, do not immerse in water for cleaning.
Make sure the brush is completely dry before replacing it.
-
6. TROUBLESHOOTING
Error codes
Error code
Error description
E1
Battery overvoltage
E2
Undervoltage or significant battery voltage difference.
E3
Undervoltage, overvoltage or overcurrent of the charger
E4
Switch failure, cannot switch on
E5
Thermistor failure
E6
Main motor disconnected or engine failure
E8
Main motor overload
E9
Main motor short circuit
ENGLISH
CONGA ROCKSTAR 7500 ASTRAL FLEX ANIMAL
41
Publicité
