Publicité
7. $"# )) #'&$
• Always make sure to install the
protected from rain and moisture.
• Make all necessary connections : 3&! applying power to the device.
• The
can be connected to the mixer in either mono or stereo mode.
Mono mode setup
• To use the device in mono mode, connect the jack inputs from channel 1 ( ) and channel 2 (6)
together and plug the connector coming from the mixer in the XLR3 connector from channel 1 ( ).
• To use the device in stereo mode, simply connect the XLR3 connectors coming from the mixer in
channel 1 ( ) and channel 2 (6).
• The satellites must be connected via a male,male NL4 Speakon
• With the signal ground/lift switch (@), the grounding mode can be selected.
" ##'$- =2 $ #2 % +'( '" &33A
• Verify that the power switch (
• Switch the power switch (
turn on.
• To replace the fuse (
the fuse with a new fuse with the same specifications. Reinstall the plastic cover and reapply
power to the device.
8. 7! $" &!# #'&$
00 (28/07/2008)
All manuals and user guides at all-guides.com
subwoofer and satellites on a flat and stable surface,
Stereo mode setup
) is in the OFF,position and plug the power cable in (B).
) to the ON,position. The power LED ( ) on top of the subwoofer will
), disconnect the power cable, unscrew the protective cover and replace
• To transport the system, simply set the subwoofer on its casters and
place the satellites onto the subwoofer with the acoustic grille facing
down.
• Secure the satellites to the subwoofer with a locking strap (not
included).
• Always handle the device with care.
A. input 1 from mixer
B. input 2 from mixer
®
cable to the subwoofer (9).
4
$)< (2 $- #2'"
HQPOWER
Publicité
