Publicité
1. Remove Tow Hitch Cover - Using a flat screwdriver, remove (9) push-pin fasteners from bottom area rear Bumper Fascia that hold Tow Hitch Cover and
Bumper Fascia to Fascia Support Panel. From underneath, see Figure 2, remove (2) clips holding Tow Hitch Cover to Bumper Fascia. Return Tow Hitch Cover
and (2) Clips to vehicle owner.
Tow Hitch Cover
Fascia Support Panel
2. Remove Fascia Support Panel - Using a 10mm socket remove (2) screws
(1 per side). Using pliers, remove (2) square shaped plastic retaining clips
by rotating clip 1/4 turn. See Figures 1, 2, 3.
Figure 3.
©2024 Horizon Global Corporation- Printed in México
Figure 1.
3. Enlarge Access Hole – Using a die grinder with burr bit, enlarge existing
hole in bottom of frame rail enough to fit 1" wide spacer block (item 4).
Sheet 5 of 21
Figure 2.
Enlarge Access Hole, both sides
Figure 4.
76649NP
6-5-24
Clip
Rev. A
Publicité
