Publicité
Open the magazine
Remove the jammed staple from the magazine
Note: Do not trigger the staple gun when empty to prevent wear.
Determining the Staple Length
Consider two factors when determining the correct staple length:
- the thickness of the material being fastened
- the composition (hardness) of the material being fastened.
4–6 mm staple or 6–8 mm nail in length will typically suffice when
driving into plywood and fiber board.
8–12 mm staple or 10 mm nail in length will typically suffice when
fastening into softwood such as pinewood.
The crown of the staple or head of the nail should be flushed with the
top of the material being fastened as shown.
If the crown of the staple or head of the nail is not flush with the top of
the material being fastened, it means it is too long. In this case, use the
next shorter staple or nail for optimal results.
and pull back on the pusher
4
.
3
.
4
GB/IE
43
Publicité
