Publicité
Starting the charging process (see Fig. A)
Connect the USB cable
Connect the other end of the USB cable
socket
on the product.
2
Connect the charger
source. The charge indicator
will light up red whilst charging. Once the battery is charged up, it
lights up green.
Completing the charging process
Disconnect the charger
Disconnect the USB cable
the product.
Note: The product cannot be used whilst charging. It is normal
for the handle to warm up slightly whilst charging.
Initial use
Adding staples
Set the On / Off switch
the product.
Turn the product over.
Squeeze the release button
Pull back on the pusher
Add staples to the magazine
After adding staples, slide the pusher
zine
is fully closed. Release the release button
4
and lock into place for the magazine
Note: Use the window on the fill indicator
zine
is empty.
4
to the USB port
7a
to a 100–240 V∼ 50 / 60 Hz power
7
shows the charging progress. It
9
from the power source.
7
from the USB Type C socket
7a
to the "0" position before working on
8
(see Fig. B).
3a
(see Fig. B).
3
(see Fig. C).
4
4
of charger
7b
to the USB Type C
7a
in again until the maga-
3
. It must click
3a
to be closed correctly.
to see if the maga-
5
.
7
on
2
GB/IE
41
Publicité
