Publicité
Installing your new appliance
It may not work properly if left at a
temperature
above
indicated range for a long period of time.
Climate
Ambient
SN
+10°C to +32°C
class
temperature
N
+16°C to +32°C
ST
+16°C to +38°C
T
+16°C to +43°C
Place your appliance in a dry
•
place to avoid high moisture.
Keep the appliance out of direct
•
sunlight, rain or frost. Keep the
appliance away from heat sources
such as stoves, fires or heaters.
Leveling of appliance
•
For the appliance to be sufficiently
leveled, and the air to circulate
correctly in the lower rear section
of the appliance, the bottom feet
may need to be adjusted. You can
adjust them manually by hand or
by using a suitable spanner.
•
To allow the
doors to self-
close, tilt the
top backwards
by
about
10mm.
Installing the door handles
For the convenience of transportation,
the door handles are separately provided
in a plastic bag, you can install the door
handles as follows.
Lever screw covers on the left side of
1.
the door, and then put them back to
the plastic bag.
Match the handle on the left side of
2.
the door, keeping axes of screw holes
in the handle and the door in a line, as
shown in the following picture.
or
below
the
Fix the handle with the special screws
3.
provided in the plastic bag. And then
install the handle covers.
Reversing the door
The side at which the door opens can be
changed,
supplied)
installation site requires.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed
from the mains socket.
Tools you will need:
8mm socket wrench
Thin-blade screwdriver
Note:
refrigerator on its back in order to gain
access to the base. You should rest it on
soft foam packaging or similar material to
avoid damaging the backboard of the
refrigerator. To reverse the door, the
following
recommended.
Stand the refrigerator upright. Open
1.
the upper door to take out all door
racks (to avoid damaging the rack)
and then close the door.
9
from
the
right
side
to
the
left
side,
Cross shaped screwdriver
8mm socket wrench
8mm wrench
screwdriver
Before
you
start,
steps
are
(as
if
the
lay
the
generally
Publicité
