Symbols on the unit
Installation variants
• Variant (a): Water flow only via the filter housing (inlet 1).
– Set inlet 2 to position "0".
– Close inlet 2 using the cover cap. (→ Overview)
• Variant (b): Water flow via the filter housing (inlet 1) and additionally via a satellite filter or
a skimmer on inlet 2.
– Set inlet 2 to position "1", "2" or "3", depending on the desired flow ratio (25/50/75 %).
• Variant (c): Water flow only via a satellite filter or a skimmer on inlet 2.
– Set inlet 2 to position "4".
• Variant (d): Dry pump installation.
– This variant requires the pump to be installed without a filter housing.
– The pump is installed outside of the pond but lower than the water level.
– If larger particles (∅ > 11 mm) may be drawn in, we recommend installing a satellite filter or a
skimmer on the intake side.
The unit is dust-tight and water-tight down to 4 m.
Possible danger for persons with pacemakers.
Protect the unit from direct sunlight.
Do not dispose of the unit with normal household waste.
Read the operating instructions.
EN
AMX0200
25