Publicité
Installation instructions
1. Drill three holes for mounting on the ceiling or wall.
2. Place the dome base at the pre-drilled installation position and fix it by using
mounting screws.
3. Route the power & ethernet cable to the connecting place.
4. Adjust the camera's viewing angle (Pan, Tilt, Rotation)
5. Assemble the dome cover to the dome base unit.
CAUTION:
Extreme care should be taken NOT to scratch the lens and the
bubble dome surface while the camera installing or adjusting.
Care should be taken the cable is NOT to be damaged, kinked or
exposed in the hazardous area. Do not expose the camera direct-
ly to a strong light source such as the sun or spot light.
Plastic Anchor (6x30mm)
Mounting Screw (4x25mm)
EN
7
Publicité
