Sartorius Celsius S3 Mode D'emploi page 19

Les langues disponibles

Fig. 12: Cryopilot A Serial Port

_Manual_Benchtop_Freeze_Thaw_System_S--6004-t210308_85034-538-54.indb 19

NOTE

Mixer speed settings may vary according to customer product

characterization. Contact Sartorius to discuss variations from the above

recommendations.

Place the Manual | Automatic switch on the back of the Cryomixer Jr. to

the automatic position (up).

4.9

Computer Setup

Plug the computer and display into the electrical supply. It is

recommended that you use a surge protector (not included).

Turn on the computer and display. Answer the questions in the Windows

"first boot" setup dialogs. It may be necessary to obtain some information

from your Information Technology (IT) department.

CAUTION

Computers supplied by Sartorius do not have antivirus software installed. It

is recommended that you install antivirus software according to your

company's policy.

4.10 Data Acquisition Setup

Connect the National Instruments USB-9213 to the computer with a

USB cable.

Connect one end of the USB to Cryomixer Jr. cable to the receptacle at

the rear of the Cryomixer Jr. Plug the other end into a USB port on the

computer.

For S³ Modules, plug the bundle of male thermocouple connectors

extending from the S³ Module into the thermocouple breakout cable.

Plug connector 1 into receptacle 1, connector 2 into receptacle 2, and

so on. Plug the Celsius

Pak thermocouples into the receptacle strip

located within the S³ hood enclosure area.

Connect one end of the USB to Unistat cable to a USB port on the

computer and the other end to the serial port on the underside of the

ComBox as shown in Figure 12. The ComBox is located at the rear of

the Cryopilot A.

Operating Instructions Celsius

System Installation

Benchtop System

01.04.2022 09:52:14