Sartorius Celsius S3 Mode D'emploi page 13

Les langues disponibles

_Manual_Benchtop_Freeze_Thaw_System_S--6004-t210308_85034-538-54.indb 13

System Installation

This chapter will guide you through the setup of the benchtop system.

4.1

Tools | Equipment Required for Installation

The following tools are needed to set up the Benchtop Freeze-Thaw

System:

— Assortment of cross head and flat head screw drivers

— Vise grip wrench with a minimum 6" (15 cm) handle

— Assortment of box or crescent wrenches

— Absorbent material such as polypropylene pads for cleaning up any

spilled HTF

— Multimeter suitable for measurement of supply voltage

4.2

System Component Inventory

When all the equipment containers are unpacked, confirm that the

following parts are available for installation:

— Cryopilot A

— Cryowedge or S³ Module

— Cryomixer Jr.

— (2) Cryohoses

— (4) Cryowraps

— T-Type thermocouples (up to 10 depending on system)

— USB to Cryomixer Jr. cable

— Computer with Cryopilot Software

— National Instruments USB-9213 data acquisition device

— USB to Unistat cable

— Dow Syltherm HF heat transfer fluid (~19 L or 5 gallons)

— Safety Siphon

— Cryowedge insulated cover (Cryowedge only)

— Three Cryocassettes (Cryowedge only)

— (10) Celsius

Paks (S³ Module only)

— (10) Thermocouple holders (S³ Module only)

— Clamp release tool (S³ Module only)

Operating Instructions Celsius

System Installation

Benchtop System

01.04.2022 09:52:13