Sartorius Celsius S3 Mode D'emploi page 16

System Installation
3
Fig. 7: S³ Module Positioning
16 Operating Instructions Celsius
_Manual_Benchtop_Freeze_Thaw_System_S--6004-t210308_85034-538-54.indb 16 _Manual_Benchtop_Freeze_Thaw_System_S--6004-t210308_85034-538-54.indb 16
Place the S³ Module on top of the Cryomixer Jr. as shown in Figure 7 so
t
that the motion of the Cryomixer Jr. will allow for mixing along the length
of a Celsius Pak.
®
Pos . Description
1 Outlet Port
2 Inlet Port
3 Mounting Knobs
1
2 Secure the S³ Module to the Cryomixer Jr. plate by tightening the four
t
mounting knobs at the bottom of the module.
Slide two Cryowraps onto each hose.
t
NOTE
The quick disconnects are factory assembled onto the S³ and hoses. If it
becomes necessary to break and then remake connections having tapered
threaded fittings, use a thread sealant such as Loctite 567.
S Module
3
Male ⅜"
quick
disconnect
Fig. 8: Cryohose Installation for S³ Module
Connect the port labeled "Thermofluid out" on the Cryopilot A to the
t
inlet port of the S³ Module. The inlet port is the lower of the two quick-
disconnect ports on the S³.
Connect the port labeled "Thermofluid in" on the Cryopilot A to the
t
outlet port of the S³ Module. The outlet port is the upper of the two
quick-disconnect ports on the S³.
Verify that all hoses are connected properly.
t
S Benchtop System
® 3
M16x 1 union M24x 1.5 union
Adapter M16x 1 union
Adapter
Female ⅜" Insulated hose
quick 1.5 m
disconnect
Cryopilot A
01.04.2022 09:52:14 01.04.2022 09:52:14