Makita PTM0900 Manuel D'utilisation page 125

TROUBLESHOOTING
PROBLEM LIKELY CAUSE
7. The motor shuts The safety device of the electronic cir-
down whilst working cuit board has cut in due to:
– battery contains electrolyte but is not
– the safety devices have cut in
8. The blades do not – problems with engagement mecha-
engage
9. Uneven cut and – cutting deck not parallel to the
poor grass collection
– blade cuts badly
– forward speed too high compared to
– collector channel is blocked
10. Unusual vibra- – cutting deck is full of grass
tions while working
– blades are unbalanced or loose
– bolts and screws are loose
11. With the engine – move the disengagement lever to
running, the machine
does not move when
the drive pedal is
pressed ( for
hydrostatic drive
models)
If problems continue after having carried out these operations, contact your dealer.
WARNING!
!
necessary equipment or the technical knowledge. The warranty is automatical-
ly voided and the manufacturer is not held responsible if repairs are done
badly.
All manuals and user guides at all-guides.com
charged
nism
ground
the height of the grass (
position «B»
Do not take on complicated repair work if you don't have the
SOLUTION
Turn the key to «STOP» and look for
the cause of the problem:
– recharge the battery (
– check that the conditions allowing
starting are met (
– contact Your Dealer
– check the tyre pressure (
– realign the cutting deck (
– contact Your Dealer
– reduce forward speed and/or raise
5.4.5) the cutting deck
– wait for the grass to dry
– remove the grass-catcher and
empty the collector channel
( 5.4.7)
– clean the cutting deck (
– contact Your Dealer
– check and tighten all the engine and
frame bolts
– move it to position «A» (
39
EN
6.2.4)
5.2.b)
5.3.2)
6.3.2)
5.4.10)
4.33)