Makita PTM0900 Manuel D'utilisation page 124

38
EN
7. TROUBLESHOOTING
PROBLEM LIKELY CAUSE
1. When the key is The safety device of the electronic cir-
turned to "RUN", the cuit board has cut in due to:
indicator light or the
control panel remain – badly connected battery
switched off – battery terminals crossed
– completely flat battery or eroded bat-
– fuse blown
– electronic circuit board wet
2. With the key on – conditions are not met to allow start-
«START» the light
flashes and the
starter motor does
not run
3. With the key is – insufficiently charged battery
turned to "START" – malfunction on the starter relay
the light or the con-
trol panel come on,
but the starter motor
is not activated
4. With the key on – insufficiently charged battery
«START», the starter – faulty fuel supply
motor runs but the
engine does not start
– faulty ignition
5. Starting is difficult – fault in carburation
or the engine runs
erratically
6. Poor engine per- – forward speed too high compared to
formance during cut-
ting
All manuals and user guides at all-guides.com
tery plates
ing
cutting height ( 5.4.5)
TROUBLESHOOTING
SOLUTION
Turn the key to «STOP» and look for
the cause of the problem:
– check connections (
– check connections (
– recharge the battery (
– replace the fuse (10 A) (
– dry using tepid air
– check that the conditions allowing
starting are met ( 5.2.a)
– recharge the battery (
– contact Your Dealer
– recharge the battery (
– check the level in the tank
( 5.3.3)
– open the fuel stopcock (
sent) ( 5.4.1)
– check the fuel filter
– check that spark plug cap is secure-
ly fitted
– check that the electrodes are clean
and have the correct gap
– clean or replace the air filter
– empty the fuel tank and refill with
fresh fuel
– check and replace the fuel filter if
necessary
– reduce the forward speed and/or
raise the cutting deck
3.4)
3.4)
6.2.4)
6.4.4)
6.2.4)
6.2.4)
if pre-