7.9 Electrical connection
WARNING OF ELECTRICAL ENERGY!
RISK OF FATAL INJURY!
Live components have been installed near this
symbol. Covers bearing this sign may only be
removed by a certifi ed skilled electrician.
•
The electrical connection must be carried out by a
qualifi ed electrician who is authorised to carry out
such work!
•
Statutory regulations and the connection
specifi cations issued by the local power supply
company must be strictly observed.
•
When connecting the appliance it must be ensured
that there is a device which makes it possible to
universally disconnect it from the mains with a contact
opening width of at least 3mm. Line-protecting
switches, fuses or contactors are suitable cut-out
devices. When connecting and repairing the appliance
disconnect it from the electricity supply with one of
these devices.
•
The earth wire must be suffi ciently long so that if the
strain relief fails, the live wires of the connecting cable
are subjected to tension before the earth wire.
•
Any superfl uous cable must be removed from the
installation area beneath the appliance.
•
Make sure that the local mains voltage is the same as
the voltage on the rating label.
•
Full protection against accidental contact must be
ensured on installation.
•
Attention: Incorrect connection may result in the power
electronics unit being destroyed.
•
The appliance is only authorised for permanent
connection. It may not be connected with a shock-
proof plug.
Instructions for assembly
Power supply
Mains voltage: 380-415V 2N~, 50/60Hz
Component rated voltage: 220-240V
Mains cable available in the factory
•
The hob has been fi tted with a temperature-resistant
connection cable in the factory.
•
The mains connection is made according to the
connection diagram.
•
If the mains cable of this appliance is damaged it will
need to be replaced with a special connection cable.
In order to avoid any risks, this must be carried out by
the manufacturer or his Customer Service.
220-240V 1~
ENG
380-415V 2N~
43