Benthaus Onyx 8O2K Studio Instructions De Montage page 32

Cooking level
Cooking level
1
2
3
4
5
6
7
8
9
120 Min.
32
Automatic boost
function
Time (min:sec)
0:40
01:12
02:00
02:56
04:16
07:12
02:00
03:12
-
Operation
4.14 Bridging function
The front and the rear cooking zones may be activated
together for a cooking process (bridging function). This
enables larger cookware to be used.
1. Turn the regulators of the front and back cooking zones
simultaneously to the right until they stop and keep them
turned for approx. 2 seconds.
The bridging function is activated, the symbol
Operation is carried out with the control knob of the front
cooking zone.
2. To deactivate press them simultaneously again or switch
off the hob.
Please note
The roaster or the pot will need to cover at least half of the
cooking zones used in order to be recognised by the pan
recognition device!
4.15 Automatic boost function
Food is parboiled at power level 9 with the automatic boost
function. After a certain time, the power level will switch
down automatically to a lower simmering setting (1 to 8).
When using the automatic boost function only the simmering
setting with which the food is to be cooked through needs
to be selected since the electronic unit switches down
automatically.
The automatic boost function is suitable for dishes which
are cold initially and are then heated up at high power.
These dishes do not need to be constantly monitored when
simmering (e.g. boiling meat for soups).
1. Turn the respective regulator to the left until it stops and
keep it turned for approx. 2 seconds.
2. Immediately turn the regulator back to the required
simmering setting. The automatic parboiling mode will
then have been activated.
The automatic boost function will operate as
programmed. After a certain time (see chart) the cooking
process will be continued with the simmering setting. The
A symbol will go off .
Please note
• The simmering setting can be raised while the automatic
boost function is in operation. A reduction in the
simmering setting will switch off the automatic boost
function.
4.16 Keep-warm function
With the keep-warm function you keep food warm with
a specifi c temperature. The respective cooking zone is
operated at a low power level.
1. Turn the regulator to the right into the required position:
corresponds to about 42°C
corresponds to about 70°C
corresponds to about 94°C
2. The keep-warm function is available for 120 minutes,
after which the cooking zone will be switched off .
ENG
appears.