Fagor WC-28DZ Manuel D'instructions page 16

MOVING YOUR APPLIANCE
•
Remove all items from inside the unit.
•
Securely tape down all loose parts (shelves)
inside your appliance. We recommend using
masking tape or any tape with an easily
removable adhesive so as to not ruin any finish
on your unit.
•
Turn the adjustable leg up towards the base to
avoid damage.
•
Tape the door shut.
•
Make sure the appliance stays secure in the
upright position during transportation. Also,
protect the outside of the appliance with a thick
blanket or similar item.
PROBLEMS WITH YOUR APPLIANCE
You can solve many common problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling customer service.
TROUBLESHOOTING GUIDE
PROBLEM
Appliance does not
operate.
Appliance is not cold
enough.
Appliance turns itself
on and off frequently.
POSSIBLE CAUSE
1. Appliance is not connected to a power supply.
2. The appliance is turned off.
3. The circuit breaker tripped or blew fuse.
1. The temperature is not set correctly.
2. The ambient temperature could require an
adjusted temperature setting.
3. The door was opened too often or held open for
too long.
4. The door was not closed completely.
5. Door is not sealed tight enough.
6. The condenser is too dirty.
7. The ventilation opening is blocked or too dusty.
1. The room temperature is higher than average.
2. A large amount of bottles has been added to
the unit.
3. The door is opened too often.
4. The door is not closed completely.
5. The door gasket does not seal properly.
ENERGY SAVING TIPS
•
The appliance should be located in the coolest
area of the room, away from heat producing
appliances and out of direct sunlight.
•
Ensure that the unit is adequately ventilated.
Never cover air vents. Clean dust and dirt from
the condenser regularly.
•
Only open the door for as long as necessary and
for as short a time as possible.
•
Store your contents in an organized way.
•
Do not over-fill the appliance in order to better
allow air to circulate.
16
REMEDY
1. Connect the appliance.
2. Switch on the appliance.
3. Switch on circuit breaker or
replace fuse.
1. Check the set temperature.
2. Set a higher temperature.
3. Do not open the door more than
necessary.
4. Close door properly.
5. Check that the door seal is
clean and replace if necessary.
6. Clean the condenser when
necessary.
7. Clear the obstructions and clean
the dust.
1. Put the appliance in a cooler
place.
2. Leave the appliance untouched
for a while until the set
temperature has been reached.
3. Do not open the door more often
than necessary.
4. Close door properly.
5. Check that the door seal is
clean and replace if necessary.