Publicité
Les langues disponibles
Les langues disponibles
Setting the Temperature Control
•
The unit has three temperature zones.
-
The temperature for the UPPER zone can
be set between 52ºF and 68ºF (11ºC-
20ºC). The default temperature is 65ºF
(18ºC).
-
The temperature for the MIDDLE zone
can be set between 41ºF and 52ºF (5ºC-
11ºC). The default temperature is 46ºF
(8ºC).
-
The temperature for the LOWER zone
can be set between 52ºF and 56ºF (11ºC-
13ºC). The default temperature is 54ºF
(12ºC).
•
When the unit is plugged in for the first time, the
unit will power up automatically to the preset
defaults.
•
Temperature control for the UPPER and
MIDDLE temperature zones is the upper control
panel.
Temperature
temperature zone is the lower control panel.
•
The temperature that you desire to set will
increase 1ºF or 1ºC if you press the UP button
once. The temperature will decrease 1ºF or 1ºC
if you press the DOWN button once. The
display will flash while you make your selection.
TEMPERATURE DISPLAY
During normal operation, the temperature display on
the
control
panel
temperature. The temperature display will flash if:
-
A different temperature is being set.
-
The temperature in the zone deviates by more
than 9°F or 5°C from the set temperature.
The temperature display flashing ensures that the
temperature cannot rise or fall un-noticed.
TEMPERATURE MEMORY FUNCTION
In the event of a power interruption
breaker switch failure,
the last temperature settings and, when the power is
recovered, the cabinet temperature will go back to
the same set temperature as before the power
interruption.
TEMPERATURE ALARM
An alarm will sound if the temperature in one of the
zones rises or falls outside the temperature range.
The relevant temperature display will flash at the
same time.
control
for
LOWER
always
shows
the
(power surge,
etc.), the unit will remember
The temperature the appliance is set at determines
the temperature the appliance recognizes as being
too warm or too cool.
The alarm will sound and the temperature display
will flash:
-
If the temperature inside the appliance is very
different from the temperature set.
-
When there has been a lengthy interruption to
the power supply.
-
When too many items have been
unit at one time. This can be as a result of
holding the door open too long or from
overloading the unit past its recommended
capacity.
-
When
THE
PRESSING THE POWER BUTTON
DOOR ALARM
If the door has been left open for more than 60
seconds, the alarm will sound.
Once the set temperature has been reached in the
appliance, the alarm stops and the relevant
temperature display stops flashing. However, if the
noise disturbs you, you can switch the alarm off
SET
before this if you wish by pressing the POWER
button once. The alarm will stop. The relevant
temperature display continues to flash until the set
temperature has been reached. The display then
lights up constantly and the alarm system is fully
active again.
INTERIOR LIGHT
The interior light makes it easy to view your wine
labels and enhances the display of your collection.
Touching the LIGHT button toggles between 2
modes of operation for the internal lights: functional
(default) mode and showcase mode. If you are in
functional (default) mode, the lights will turn on only
when the door is open. If you are in showcase mode,
the lights will remain on whether or not the door is
open.
The unit is equipped with a LED light fitting system.
To change the LED light fitting please contact the
service department.
NOTE: Please use only the original LED light fittings
provided by the manufacturer.
12
the door is not been closed tightly.
ALARM
CAN
BE
put into the
DEACTIVATED
BY
Publicité
