Publicité
INSTALLATION
Installing the oven
The kitchen area should be dry and
aired and equipped with efficient ven-
tillation. When installing the oven, easy
access to all control elements should
be ensured.
This is a Y–type design built–in oven,
which means that its back wall and one
side wall can be placed next to a high
piece of furniture or a wall. Coating or
veneer used on fitted furniture must be
applied with a heat–resistant adhesive
(100°C). This prevents surface defor-
mation or detachment of the coating.
Hoods should be installed according to
the manufacturer's instructions.
Make an opening with the dimensions
given in the diagram for the oven to be
fitted.
Make sure the mains plug is disconnec-
ted and then connect the oven to the
mains supply.
Insert the oven completely into the ope-
ning without allowing the four screws in
the places shown in the diagram to fall
out.
Electrical connection
● The oven is manufactured to work with
a one-phase alternating current (230V
1N~50 Hz) and is equipped with a with
a plug including a protection contact.
● A connection socket for electricity
supply should be equipped with a
protection pin and may not be located
above the cooker. After the cooker is
positioned, it is necessary to make the
connection socket accessible to the
user.
● Before connecting the oven to the soc-
ket, check if:
- the fuse and electricity supply are able
to withstand the cooker load,
- the electricity supply is equipped with
an efficacious ground system which
meets the requirements of current stan-
dards and provisions,
- the plug is within easy reach.
Important!
If the fixed power supply cable is damaged,
it should be replaced at the manufacturer
or at an authorized servicing outlet, or by a
qualified person to avoid danger.
76
Publicité
