Publicité
CAUTION :
Before any action on the pump, shut off the compressed air supply and
depressurize the system.
The pump is manufactured under the ATEX agreement and can not be modified.
SAMES KREMLIN will not be held responsible for any failure to comply with that instruction.
FLUID MOTOR OR AIR MOTOR REPLACEMENT (REFER TO DOC. 573.412.050 & 573.413.050)
Guards (air motor cover, coupling shields, housings ...) have been designed for
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial removal of the guards.
Position the air motor piston in a high position before shutting off the compressed air and before
depressurizing the system.
Disassemble all the accessories of the pump (rods, filter).
Disassemble the pump from the cart, then from the bracket by removing the nuts that hold on the U-
bolts.
Put aside the pump (the pump is fitted with an hoisting ring).
Remove the 3 nuts (4) that hold on the 3 tie-rods (3).
Disassemble the air motor from the fluid section by removing the coupling rod from the air motor
and the piston from the air motor (hold on the coupling rod and unscrew the piston by means of a
wrench).
When changing the fluid section :
Position the spring protection on the new fluid section piston, assemble the air motor and the fluid
section, the tie-rods and the nuts.
Position the whole on the wall mounted unit.
When changing the air motor :
Remove the air supply from the old air motor and assemble it on the new one.
Assemble the new air motor and the fluid section (as it is specified previously).
Fix the pump on its bracket.
SAMES KREMLIN
safe use of the equipment.
- 1 -
N° : 578.155.110-UK-2108
Publicité
