Publicité
Installation instructions for mounting brackets and pressure washer unit
Steps
Preliminary Checks
Positioning the Brackets
Leveling
Mounting Preparation
Mounting the Brackets
Mounting the Pressure
Washer
Finalization
Final Check
Wood studs
•
Use a stud finder to locate the
studs in the wall.
•
Position the brackets against the
studs in the wall.
•
Use a level to ensure that both brackets are perfectly aligned and level.
•
Mark the locations where you will
insert the screws based on the
positioning of the brackets.
•
Use a drill with a 7/32'' bit to drill
pilot holes at the marked
locations.
•
Place the provided rubber shock
absorbing pads between the wall
and the wall bracket and insert the
screw with a washer through the
bracket and the rubber.
•
Screw into the pre-drilled holes.
•
Carefully lift the pressure washer and place it onto the brackets, ensuring it is level
and stable.
WARNING: The unit is heavy and should be lifter by 2 persons or a chain block.
•
Ensure that the cleaner is correctly positioned in the bracket.
•
Tighten the set screws to secure the unit to the bracket.
•
Secure the bottom of the brackets to the unit plate with the bolts and nuts
provided for a complete and secure installation.
•
Make sure the pressure washer is securely mounted to the bracket and the entire
assembly is stable.
•
Your wall mount is now properly installed and ready to support your pressure
washer.
•
Be sure to follow these instructions carefully for a safe and secure installation.
•
If you have any doubts or questions, do not hesitate to contact MS Gregson for
further assistance.
38/48
Brick, cement or concrete wall
•
Make sure the wall you are mounting the
bracket to is strong enough to support
the weight of the pressure washer.
•
Space the brackets as far apart as
possible for better weight distribution.
•
Mark the locations where you will insert
the anchors based on the positioning of
the brackets.
•
Use a hammer drill with a 1/2'' concrete
bit to drill pilot holes at the marked
locations.
•
Insert the anchors into the pre-drilled
holes.
•
Place the provided rubber shock
absorbing pads between the wall and the
wall bracket and insert the screw with a
washer through the bracket and the
rubber.
•
Screw into the anchor.
Publicité
