Grundig 01M-GRN0695-3520-02 Mode D'emploi page 22

RADIO OPERATION
General functions
Switching on and off
1
Press »ON/OFF« to switch the device on and
off.
Adjusting the volume
1 Adjust the volume using »
Adjusting the tone
1
Adjust the tone using »
DAB mode
For the best DAB reception, it is sufficient to extend
the telescopic antenna and direct it accordingly.
Selecting the input source DAB
1
Select the audio sources DAB radio with
»MODE/AL«.
– Display: »DAB«, then the name of a DAB ra-
dio station.
Selecting stored stations
1 Select the station you want using the preset but-
tons »1, 2, 3, 4, 5« (presets 1 to 5) or using
»+ 5« and the preset buttons »1, 2, 3, 4, 5«
(presets 6 to 10);
or
select the desired station by pressing
»– TUNING +«.
Displaying DAB station information
1
To display information on the current DAB sta-
tion, press »SEL/i/ATS« repeatedly.
– The following display appears in succession:
Information from the provider (e.g. to the ac-
tual broadcast, the title of the song, the e-mail
address), the signal strength, the genre, the
current frequency, reference to signal interfer-
ence (at optimum signal display »ERR: 0«)
the bit rate, the broadcasting format, the cur-
rent time and date.
22 ENGLISH
-------------------------------------------------------------------------------------------------
+ VOL.
–«.
!
"
«.
Setting Dynamic Range Control
(DRC) for DAB stations
When you activate Dynamic Range Control, you
can hear lower sounds better in a loud environ-
ment.
1
Open the menu with »MENU«.
2 Select the option »DRC« with
and confirm by pressing »SEL/i/ATS«.
– Display: »DRC OFF«.
3
Select the option "DRC LOW" or "DRC HIGH"
»– TUNING +« and confirm by pressing
with
»SEL/i/ATS«.
4
Press »MENU« to end the display.
Note:
The DAB station must support DRC.
7
FM mode
For the best FM reception, it is sufficient to extend
the telescopic antenna and direct it accordingly.
Selecting the input source FM
1 Select the audio sources FM radio with
»MODE/AL«.
– Display: »FM«, then the frequency of a FM
radio station.
Selecting stored stations
1
Select the station you want using the preset but-
tons »1, 2, 3, 4, 5« (presets 1 to 5) or using
5« and the preset buttons »1, 2, 3, 4, 5«
»+
(presets 6 to 10).
Displaying RDS station informations
RDS (Radio Data System) is an information sys-
tem which is transmitted additionally by most FM
stations.
Notes:
It may take some time before all RDS infor-
7
mation is available.
GRUNDIG has no influence on the correct-
7
ness of such information.
1
Press »SEL/i/ATS« repeatedly.
– The following display appears in succesion:
radio text (if offered), station type (PTY),
name of the radio station, the current time
and date.
»– TUNING +«